ATNEL tech-forum https://forum.atnel.pl/ |
|
Błędne wskazania czujnika wilgotności https://forum.atnel.pl/topic22544.html |
Strona 1 z 1 |
Autor: | rskup [ 8 wrz 2019, o 13:42 ] |
Tytuł: | Re: Błędne wskazania czujnika wilgotności |
A widziałeś w dokumentacji: Due to normal variations in RH accuracy of the device as described in Table 4, it is possible for the measured value of %RH to be slightly less than 0 when the actual RH level is close to or equal to 0. Similarly, the measured value of %RH may be slightly greater than 100 when the actual RH level is close to or equal to 100. This is expected behavior, and it is acceptable to limit the range of RH results to 0 to 100%RH in the host software by truncating values that are slightly outside of this range -- Pozdrawiam, Robert ------------------------ [ Dodano po: 11 minutach ] A tak dodatkowo, to dlaczego robisz |
Autor: | Semi [ 8 wrz 2019, o 17:40 ] |
Tytuł: | Re: Błędne wskazania czujnika wilgotności |
rskup napisał(a): A widziałeś w dokumentacji: Due to normal variations in RH accuracy of the device as described in Table 4, it is possible for the measured value of %RH to be slightly less than 0 when the actual RH level is close to or equal to 0. Similarly, the measured value of %RH may be slightly greater than 100 when the actual RH level is close to or equal to 100. This is expected behavior, and it is acceptable to limit the range of RH results to 0 to 100%RH in the host software by truncating values that are slightly outside of this range 250% to nieco ponad 100? |
Strona 1 z 1 | Strefa czasowa: UTC + 1 |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |