Pracuje nad jednym projektem i ostatnim etapem jest wprowadzenie uC w stan uspienia. Proboje uzyskac katalogowe pobory mocy ale nie jestem w stanie. Regulator napiecia pobiera 4mA na wlasne potrzeby, a przy kodzie ponizej caly uklad pobiera 10mA. Moglbym prosic o wskazowki.
[syntax=c]#include <avr/io.h>
#include <util/delay.h>
//#include "bldc.h"
#include <avr/interrupt.h>
#include <avr/sleep.h>
#include <avr/power.h>
//------------------------------------------------------------------
int main (void)
{
//Pin kontrolny
DDRD |= ((1<<PD0)|(1<<PD1)|(1<<PD2)|(1<<PD3)|(1<<PD4)|(1<<PD5)|(1<<PD6)|(1<<PD7)); //
PORTD &= ~((1<<PD0)|(1<<PD1)|(1<<PD2)|(1<<PD3)|(1<<PD4)|(1<<PD5)|(1<<PD6)|(1<<PD7)); //
DDRC |= ((1<<PC0)|(1<<PC1)|(1<<PC2)|(1<<PC3)|(1<<PC4)|(1<<PC5)|(1<<PC6)|(1<<PC7)); //
PORTC &= ~((1<<PC0)|(1<<PC1)|(1<<PC2)|(1<<PC3)|(1<<PC4)|(1<<PC5)|(1<<PC6)|(1<<PC7)); //
DDRB |= ((1<<PB0)|(1<<PB1)|(1<<PB2)|(1<<PB3)|(1<<PB4)|(1<<PB5)|(1<<PB6)|(1<<PB7)); //
PORTB &= ~((1<<PB0)|(1<<PB1)|(1<<PB2)|(1<<PB3)|(1<<PB4)|(1<<PB5)|(1<<PB6)|(1<<PB7)); //
DDRA |= ((1<<PA0)|(1<<PA1)|(1<<PA2)|(1<<PA3)|(1<<PA4)|(1<<PA5)|(1<<PA6)|(1<<PA7)); //
PORTA &= ~((1<<PA0)|(1<<PA1)|(1<<PA2)|(1<<PA3)|(1<<PA4)|(1<<PA5)|(1<<PA6)|(1<<PA7)); //
sei();
set_sleep_mode(SLEEP_MODE_PWR_DOWN);
sleep_enable();
sleep_cpu();
/////////////////////////////////////////////////////////////////////////////// Starting Algorithm, rotor location
//////////////////// //////////////////////////////////// Main Loop
while(1){
}
}[/syntax]Statystyki: Napisane przez lukasz139 — 5 cze 2015, o 07:58
]]>